Silhouette Tile Sign

4" tiles
White Vinyl lettering Words: Love, Cherish, Adore (If you need this please contact me)
Adhesive Glitter paper
Pre-cut Silhouette
Epoxy Resin
Paint
Popsicle Stick
Soup can
Straw

• For my silhouette I took a side shot of each of my children. I know there are easier ways to do this...but I have other uses for the silhouette. So I used my pen tool in photoshop and traced around the silhouette actually turning it into a custom shape. Then I re sized the silhouette to fit the tile.

• Print and cut the silhouette.

• Cut, sand, and paint a piece of wood to fit your tiles. ( Mine ended up being 6" x 15")

• Trace your tile onto the glitter paper. You'll need one cut per tile.

• Since the glitter paper was already adhesive, I just pressed it down onto the tile.
  

• Sand the excess glitter paper (I used a belt sander) off the tile.

• Use a heavy duty glue to adhere the silhouette onto the glitter paper. (I used mod podge at first, but it didn't adhere to the glitter very well.)
  

• Make SURE the silhouette is glued well and the corners don't stick up.

• Mix your epoxy resign according to package directions. Usually it's a two part mixture. (You wont need much mixed)
  

• Prop your tiles up on a can of soup.

• Slowly drizzle about a teaspoon amount of resign on each tile. Start spreading it around with a Popsicle stick. Add more resign as needed. It won't need very much.
  

• As the resign starts to dry it will spread. If you put too much on it will run off the sides of the tile. You'll need to make sure to run a Popsicle stick underneath the tile to scrape the excess resign. DO NOT leave any amount of resign on the bottom of the tile.)

• Slowly blow through the straw to pop the tiny bubbles on the tile.

• Once again check to make sure the resign isn't on the bottom or sides of the tile.
  

• After 24 hours you can glue the tile to the board and add your vinyl lettering.
  

***If you make this I'd love to see how yours turn out.****